Knauf H PRO 100, single-component polymer-cement mixture for waterproofing price

Knauf H PRO 100, single-component polymer-cement mixture for waterproofing

25.32 € (49.52 лв.)
  • The indicated price is for a 25 kg bag.
  • Consumption rate: 1.6 kg/m²
Brand:Knauf
Product Code: 019812
Stock In stock
Have questions? Write to us or give us a call:
Free Consultation
If you're unsure which product is best for your needs, we'll help you with your choice!
Discount Inquiry
Discounts apply when purchasing large quantities of products outside of promotions.

Polymer-Cement Waterproofing 

Knauf H PRO 100 is a waterproof membrane characterized by high vapor permeability. It complies with the EN 1504-2 standard and is suitable for balconies, terraces, water tanks, underground walls, elevator shafts, and irrigation channels.

Applications:

  • Exterior walls of underground rooms
  • Interior walls of underground rooms
  • Elevator shafts
  • Irrigation channels
  • Concrete tanks
  • Wastewater tanks

Characteristics:

  • Vapor permeability
  • Excellent adhesion
  • Low absorption of capillary moisture

Composition:

The product contains sand, cement, fine fillers, redispersible powder, and other additives.

Storage:

The product should be stored in its original packaging in a cool place, protected from cold and high temperatures, at temperatures between +5°C and +25°C. Keep away from direct sunlight. The shelf life is 12 months.

Application

Preparation:

The surface must be clean, dry, solid, homogeneous, frost-free, and without cracks, grease, and oils. Remove layers that could reduce adhesion. Before application, dampen the surface and wait for the excess water to evaporate.

Application:

The material is applied with a brush or trowel. The minimum thickness should be about 2 mm, applied in at least 2-3 layers. Special attention should be paid to proper application in corners. The next layer should be applied after the previous one has dried (approximately 5 hours depending on climatic conditions).

Working Temperature:

The air, material, and substrate temperature during application should be between 5°C and 25°C.

Special Notes:

  • Not intended for solving condensation problems on interior walls.
  • Do not apply on contaminated mineral substrates, wooden bases, elastic and painted surfaces.
  • Do not apply in areas with visible water traces.
  • Freshly applied material should be protected from wind and sun.

Material Consumption:

Approximately 1.6 kg/m².

Technical Data:

  • Adhesion to the substrate: >1 N/mm²
  • Capillary water absorption coefficient: < 0.1 kg/m² h⁰.⁵
  • Water vapor diffusion resistance coefficient: <5 m

Write a review

Note: HTML is not translated!

Rating Bad           Good